Corset 3 Sewing Patterns | DRCOS Patterns & How To Make

Comments are made using translation software.

This is a pattern for a lace-up corset that emphasizes the chest.

We have redesigned the pattern with three-dimensional cutting to accentuate the body's lines, so we recommend lacing up a size smaller for a better fit.

It is shaped to fit a body divided into eight sections.

While it fastens with laces at the front, we also recommend processing it with a back zipper for convenience.

Please note that stiff fusible interlining, among the accessories required for production, is essential for stabilizing the eyelets.

Please use it after processing as a base pattern.

After printing, paste it according to the pasting line,Cut and use.

The pattern has a seam allowance, so it can be used as is.

I'm not so good at English.

So all explanations/instructions were translated using AI.

This is not always perfect and I apologise for any parts that are difficult to follow.

* If untying the laced section is inconvenient, we recommend installing an open zipper at the center back.

(1) Attach the “Fusible interlining” to the “Lining Fabric” and attach the “Stiff fusible interfacing” to the “Stiff fusible interfacing” attachment position on the “Front bodice Lining Fabric.”

(2) Sew the side seams and the center back of the “Front bodice,” “Front bodice Side,” “Back bodice Side,” and “Back bodice.”

(3) Press the seam allowances open with an iron, topstitch them open, and trim any excess seam allowance.

(4) Create the “Lining Fabric” following steps (2) and (3).

(5) Baste the “bodice” and “Lining Fabric” together around the edges and finish the edges with bias binding.

How to make bias tape

How to sew bias tape

(6) Attach the grommets at the “Grommet position,” thread the cord through, and complete the garment.

If you cannot see the SHOP due to 403 error

---

---

---

---

---

---